
Start and driving
Note
●
Before leaving the vehicle, always discon-
nect the ignition and, if appropriate, take
into account the instructions on the screen
of the dash panel.
●
If the vehicle is stationary for a long time
with the engine off and the ignition on, the
vehicle battery might be discharged and it
might not be possible to start the engine.
●
If during the STOP phase you press the
START ENGINE STOP
button, the ignition is
switched off and the button flashes.
●
If the indication is displayed on the in-
strument panel display “Start-Stop system
deactivated: Start the engine manually”,
the
START ENGINE STOP
button will blink.
Starting the engine
●
Move the selector lever to the
P
or
N
posi-
tion.
●
Press and hold the brake pedal until the
engine starts.
●
Press the starter button
; do not
press the accelerator. There needs to be a
valid key inside the vehicle for the engine to
start. After starting the engine, the lighting of
the
START ENGINE STOP
button changes to
steady lighting, indicating that the engine
has started.
●
Once the engine starts, release the start-
up button.
●
If the engine does not start, stop and wait
for around 1 minute to try again. If necessary,
perform an emergency start
.
WARNING
Never run the engine in confined spaces, as
the exhaust gases are poisonous.
●
The exhaust gases contain carbon mon-
oxide, an odourless and colourless poison-
ous gas. Risk of fatal accidents. Carbon
monoxide can cause loss of consciousness
and result in death.
WARNING
Do not get out of the vehicle with the en-
gine running, especially if a gear is engag-
ed. The vehicle could then suddenly move
or something strange could happen that
would cause damage, fire or serious injury.
WARNING
Never use cold start sprays, they could ex-
plode or cause the engine to run at high
revs. Doing this risks injury.
CAUTION
●
The starter motor or the engine may be
damaged if you try to start the engine while
driving or if you restart it immediately after
switching it off.
●
When the engine is cold, you should
avoid high engine speeds, driving at full
throttle and over-loading the engine. Risk
of engine damage.
For the sake of the environment
Do not warm-up the engine by running the
engine with the vehicle stationary. Start off
immediately, driving gently. This helps the
engine reach operating temperature faster
and reduces emissions.
Note
●
Electrical components with a high power
consumption are switched off temporarily
when the engine starts.
●
When starting with a cold engine, noise
levels may briefly increase. This is quite
normal, and no cause for concern.
Turning off the engine
●
Bring the vehicle to a full stop
●
Move the selector lever to the
P
position.
●
Apply the electronic parking brake.
●
Briefly press the start-up button
.
»
227
Содержание ATECA
