
Driving
WARNING
Quick turns of the steering wheel when
parking or exiting a parking space with Park
Assist can cause serious injury.
●
Do not hold the steering wheel during
manoeuvres to park or exit a parking space
until the system requests it. Doing so disa-
bles the system during the manoeuvre, re-
sulting in the parking being cancelled.
CAUTION
●
In certain circumstances, the ultrasonic
sensors do not detect objects such as trail-
er tongues, bars, fences, posts or thin trees,
or an open (or opening) rear lid, which
could damage the vehicle.
●
Retrofitting of certain accessories to the
vehicle, such as a bicycle rack, may inter-
fere with the operation of the Park Assist
system and cause damage.
●
The Park Assist system uses as a refer-
ence parked vehicles, curbs and other ob-
jects. Make sure that the tyres and wheels
are not damaged while parking. If necessa-
ry, opportunely interrupt the parking ma-
noeuvre to avoid damaging the vehicle.
●
The ultrasound sensors on the bumper
may be damaged or shifted in the event of a
collision, for example, when entering or ex-
iting a parking space.
●
If you use high-pressure or vapour equip-
ment to clean the ultrasound sensors, do
not apply it directly unless very briefly and
always from a distance of more than 10 cm.
●
A registration plate or plate holder on the
front with larger than the space for the reg-
istration plate, or a registration plate that is
curved or warped can cause:
–
false detections,
–
loss of sensor visibility.
–
cancellation of the parking manoeuvre
or defective parking.
●
If one of the ultrasonic sensors is dam-
aged, the area corresponding to that group
of sensors (front or rear) is deactivated and
cannot be activated until the fault is cor-
rected. However, you can still use the sen-
sors of the other bumper as per usual. If
there is a fault in the system, consult a spe-
cialist workshop. To do so, CUPRA recom-
mends going to a specialised CUPRA dealer
or any SEAT dealership.
Note
●
In order to guarantee good system opera-
tion, keep the ultrasound sensors of the
bumper clean, free of snow or ice, and do
not cover them with adhesives or other ob-
jects.
●
Certain sources of noise, such as rough
asphalt or paving stones and the noise of
other vehicles can induce the Park Assist
system or ParkPilot to give erroneous warn-
ings.
●
To become familiar with the system and
its functions, CUPRA recommends that you
practice operating the Park Assist system in
an area where there is not too much traffic
or in a car park.
Description of the parking assist sys-
tem
Fig. 232
In the upper part of the centre console:
button to switch on the Park Assist system.
The components of the Park Assist system
are the ultrasonic sensors located in the
front and rear bumpers, the
button
to switch the system on and off
and the messages on the instrument panel
display.
Prerequisites for parking
●
The traction control system (ASR) must be
turned on
284
Содержание ATECA
