Cupra ATECA, Руководство пользователя, Страница: 233 / 380

Start and driving
● Defrost function button activated
›››
page 137 .
●
The parking aid* is switched on.
●
The battery is very low.
● The steering wheel is overly turned or is
being turned.
●
If there is a danger of misting.
●
After engaging reverse gear.
●
In case of a very steep gradient.

is shown on the instrument panel display,
as well as on the driver information system*,

.
The engine starts by itself
When stopped, the normal system mode
may be interrupted in the following situa-
tions. The engine restarts by itself without in-
volvement from the driver.
● The interior temperature differs from the
temperature selected on the climate control.
●
Defrost function button activated
›››
page 137 .
●
The brake has been pressed several times
consecutively.
●
The battery is too low.
●
High power consumption.
Additional information related to the au-
tomatic gearbox
The engine stops when the selector lever is
in the positions
P , D , N and S in addition to
when in Tiptronic mode. With the selector
lever in
P , the engine will also remain switch-
ed off when you take your foot off the brake
pedal. In order to start the engine up again
the accelerator must be pressed, or another
gear engaged or the brake released.
If the selector lever is placed in
R
while stop-
ped, the engine will start up again.
Change from D to P to prevent the engine
from accidentally starting when passing
through R.
Additional information about vehicles with
Adaptive Cruise Control (ACC)
In vehicles with ACC function, the engine will
start up again in certain operating conditions
if the radar sensor detects that the vehicle
ahead drives off again.
WARNING
●
Never switch the engine off until the ve-
hicle is stationary. The operation of the
brake and steering will not be fully guaran-
teed. More force will be needed to turn the
steering wheel or to brake. You could suffer
an accident and even serious injuries.
●
To avoid injury, make sure that the Start-
Stop system is switched off when working in
the engine compartment
›››
page 232 .
CAUTION
The Start-Stop system must always be
switched off when driving through flooded
areas
›››
page 246 .
Note
●
You can control whether the engine
should switch off or not by reducing or in-
creasing the brake force applied. While the
vehicle remains stopped, the engine will
not stop if the brake pedal is slightly press-
ed, in traffic jams with frequent stopping
and starting for example. As soon as strong
pressure is applied to the brake pedal, the
engine will stop.
●
When stopped, the brake pedal must be
kept pressed to ensure that the vehicle
does not move.
●
If the lever is placed in position D, N or S
after engaging reverse gear, 10 km/h (6
mph) in a forwards direction must be
reached for the system to be in a condition
to stop the engine.
231