Club Car Pioneer 1200, Руководство по техническому обслуживанию

Страница: 325 / 360

UNITIZED TRANSAXLE WITH DIFFERENTIAL LOCK Unitized Transaxle Installation
2001 Pioneer 1200 Gasoline Vehicle Maintenance and Service Manual Page 16-43
16
25. Connect the 6 gauge white wire to the F2 post, the 6 gauge black ground wire to the A2 post and
tighten to 48 in-lb (5.4 N·m). Connect the 16 gauge yellow wire to the DF post on the starter/generator
and tighten to 30 in-lb (3.4 N·m) (Figure 16-105, Page 16-43).
26. Connect the Forward/Reverse shifter and bracket to the transaxle.
26.1. Install the three screws (2) securing the Forward/Reverse shifter cable bracket (1) to the transaxle
and tighten them to 135 in-lb (15.3 N·m) (Figure 16-40, Page 16-16).
26.2. Place the woodruff key (9) on the shifter shaft (Figure 16-40, Page 16-16).
26.3. Place the shifter lever (6) (aligned with the woodruff key) onto the Forward/Reverse shaft (15).
26.4. Install the nut (3), washer (4), and bolt (7) on the Forward/Reverse shifter lever and tighten to 36
in-lb (4.1 N·m) (Figure 16-40, Page 16-16).
26.5. Position the shifter cable in the shifter cable mounting bracket on the transaxle and tighten the
mounting nuts to 22 ft-lb (29.8 N·m). Connect shifter cable rod end to the shifter arm (Figure 16-
106, Page 16-44).
27. Attach the ground wire to the mounting screw on the oil filler tube mounting bracket and tighten to 50
in-lb (5.7 N·m) (Figure 16-107, Page 16-44).
Figure 16-103 Ignition Kill Wire
Figure 16-104 Oil Level Sensor Jumper Wire Figure 16-105 Starter/Generator
WHITE/BLACK
WIRE
BLACK
WIRE
STARTER
GENERATOR
YELLOW
OIL SENDING
UNIT JUMPER
WIRE
DF
F2
WHITE
YELLOW
GROUND