Club Car Pioneer 1200, Руководство по техническому обслуживанию

Страница: 57 / 360

HYDRAULIC AND PARK BRAKE SYSTEMS Brake Cluster Assembly Inspection and Cleaning
2001 Pioneer 1200 Gasoline Vehicle Maintenance and Service Manual Page 6-11
6
6.3. Disassemble the lever and strut by removing the c-clip and pin (Figure 6-7, Page 6-11).
6.4. Using a wire brush, remove corrosion and contaminants from the contact areas of the strut and
lever.
6.5. Using NLGI Number 2 white lithium grease, lightly lubricate the pin and contact surfaces and
reassemble the lever and strut. See following WARNING.
∆ WARNING
• Make sure the C-clip is properly seated in the groove of the pin. An improperly installed C-clip
could result in a non-functioning park brake.
• Apply grease carefully when performing the following steps. Do not allow any grease to get on
the friction surfaces of the brake shoe pads. Failure to heed this warning could cause
diminished brake performance, possibly resulting in property damage or severe personal
injury.
7. Use a small brush to carefully apply a liberal amount of white lithium NLGI Number 2 grease (Dow Corn-
ing BR2-Plus or equivalent) on each of the six raised bosses on the brake cluster backing plate (Figure
6-8, Page 6-11). See preceding WARNING.
Figure 6-7 Park Brake Lever and Strut
Figure 6-8 Lubricate Raised Bosses Figure 6-9 Lubricate Brake Cluster
LEVER
PIN
STRUT
C-CLIP
BOSSES
BOSSES
*Present on rear brake clusters only.
*
*