Club Car Pioneer 1200, Руководство по техническому обслуживанию

Страница: 180 / 360

ELECTRICAL COMPONENTS Fuse
Page 12-18 2001 Pioneer 1200 Gasoline Vehicle Maintenance and Service Manual
12
FUSE
Read DANGER and WARNING on page 12-1.
Testing the Fuse
See Test Procedure 2, Section 11, Page 11-24.
Fuse Removal
1. Disconnect the battery cables, negative cable (–) first (Figure 12-1, Page 12-2).
2. Remove electrical component box cover.
3. Remove the fuse from the fuse block.
Fuse Installation
1. Install the fuse. See following WARNING.
∆ WARNING
• If a fuse is blown, determine the cause of the failure and make necessary repairs before
installing a new fuse. Use the appropriately rated fuse; if a fuse with a higher amp rating is
used, damage to the vehicle electrical system may occur.
2. Install the snap-on electrical box cover by firmly pressing down on all corners and install the screw,
tightening to 18 in-lb (2 N·m).
3. Connect battery cables, positive cable first and tighten the terminals to 20 ft-lb (27.1 N·m). Coat termi-
nals with Battery Protector Spray (CCI 1014305).
LOCKOUT CAM LIMIT SWITCH
Read DANGER and WARNING on page 12-1.
Testing the Lockout Cam Limit Switch
See Test Procedure 7, Section 11, Page 11-28.
Lockout Cam Limit Switch Removal
1. Disconnect the battery cables, negative cable (–) first (Figure 12-1, Page 12-2).
2. Disconnect the wires from the lockout cam limit switch (5) located on the back of the Forward/Reverse
shifter assembly (Figure 12-20, Page 12-19).
3. Remove two nuts (2) and washers (6) from the lockout cam limit switch (5) and slide the lockout cam
limit switch off of the screws.