Club Car Pioneer 1200, Руководство по техническому обслуживанию

Страница: 30 / 360

BODY AND TRIM Seat Support
Page 4-6 2001 Pioneer 1200 Gasoline Vehicle Maintenance and Service Manual
4
Seat Adjustment
1. Remove seat from vehicle.
2. Disassemble bucket seat (2) from seat panel (3) by removing four bolts (4) and lock washers (5) (Fig-
ure 4-2, Page 4-7).
3. Adjust seat to suit. Align holes in seat panel with holes in bucket seat and secure with four bolts and
lock washers. Tighten bolts to 96 in-lb (10.8 N·m).
SEAT INSTALLATION
1. Align seat hinge plates with holes in seat support, lower seat and press down to lock in place. See fol-
lowing WARNING.
∆ WARNING
• Make sure seat hinges and latch are securely engaged before operating vehicle.
SEAT SUPPORT
Read WARNING and CAUTION on page 4-1.
SEAT SUPPORT REMOVAL
1. Completely remove both seats from the vehicle.
2. Remove park brake cable from park brake lever. See Equalizer Cable Removal, Section 6, Page 6-
31.
3. Disconnect cable from differential lock control. See step 3.5 of Unitized Transaxle Removal, Section
16, Page 16-9.
4. Remove the four bolts (8), eight washers (9) and four lock nuts (10) from the seat support (Figure 4-2,
Page 4-7).
5. Remove the two armrests (11 and 12) from the seat support (Figure 4-2, Page 4-7).
6. Lift seat support from vehicle.
SEAT SUPPORT INSTALLATION
1. Install the seat support and armrests. Tighten bolts (8) to 13 ft-lb (17.6 N·m) (Figure 4-2, Page 4-7).
2. Reconnect differential lock cable end to the differential lock handle. See step 33 of Unitized Transaxle
Installation, Section 16, Page 16-44.
3. Reinstall park brake cable. See Equalizer Cable Installation, Section 6, Page 6-33.