Club Car Pioneer 1200, Руководство по техническому обслуживанию

Страница: 183 / 360

ELECTRICAL COMPONENTS Reverse Buzzer Limit Switch
2001 Pioneer 1200 Gasoline Vehicle Maintenance and Service Manual Page 12-21
12
2. Connect the black wire from the wire harness to the negative (–) terminal on the buzzer.
3. Connect the red/white wire from the wire harness to the positive (+) terminal on the buzzer.
4. Reverse removal procedures to reinstall the dash panel on the vehicle.
5. Connect battery cables, positive cable first and tighten the terminals to 20 ft-lb (27.1 N·m). Coat termi-
nals with Battery Protector Spray (CCI 1014305).
REVERSE BUZZER LIMIT SWITCH
Read DANGER and WARNING on page 12-1.
Testing the Reverse Buzzer Limit Switch
See Test Procedure 19, Section 11, Page 11-37.
Reverse Buzzer Limit Switch Removal
1. Disconnect the battery cables, negative cable (–) first (Figure 12-1, Page 12-2).
2. Disconnect the wires from the reverse buzzer limit switch (4) located on the back of the Forward/
Reverse assembly (Figure 12-20, Page 12-19).
3. Remove the nuts (2) and washers (6) from the lockout cam limit switch (5) and slide the lockout cam
limit switch off of the screws. Do not disconnect the wires.
4. Remove the spacers (9) from the reverse buzzer limit switch (4) and slide the reverse buzzer limit
switch off the screws.
Reverse Buzzer Limit Switch Installation
1. Install the reverse buzzer limit switch (4), and then install two spacers (9) against the limit switch.
2. Install the lockout cam limit switch (5) with two washers (6) and two nuts (2). Tighten to 5 in-lb (0.6
N·m). See following CAUTION.
Figure 12-22 Front Reverse Warning Buzzer
BLACK GROUND
RED/WHITE
2
3