Club Car Pioneer 1200, Руководство по техническому обслуживанию

Страница: 261 / 360

FUEL SYSTEM Engine Control Linkage
2001 Pioneer 1200 Gasoline Vehicle Maintenance and Service Manual Page 14-11
14
5. With the governor lever arm loose on the governor shaft, use a 1/8 inch punch or scratch awl to turn the
governor arm shaft counterclockwise until it stops. Then pull the governor lever arm rearward until the
carburetor throttle is in the “wide open throttle” (WOT) position.
6. While holding the arm and shaft in the fully counterclockwise position, tighten the governor arm lever
nut to 36 in-lb (4.0 N·m).
7. Check engine RPM adjustment. See Engine RPM Adjustment on page 14-13.
ACCELERATOR CABLE
Accelerator Cable Removal
1. Access the engine compartment. See DANGER on page 14-1.
1.1. Tilt the bed and ensure that the prop rod is engaged.
2. Remove the electrical box cover and loosen the cable housing retaining nuts (Figure 14-9, Page 14-
11).
3. Disconnect cable (1) from cam (17) in the electrical box (Figure 14-11, Page 14-12).
4. Remove the E-ring (7) on the spring end of the cable at the accelerator cable bracket (5) (Figure 14-11,
Page 14-12). Pull the cable housing out of the bracket.
5. Disconnect the spring (16) from the engine governor arm by rotating the arm counterclockwise one-half
turn. Remove the cable assembly from the vehicle (Figure 14-11, Page 14-12).
Figure 14-9 Cam Position Figure 14-10 Accelerator Rod
RETAINING
NUTS
CAM
PARALLEL
WITH
BOX
PULL SPRING RELEASE
TO INSTALL
ACCELERATOR ROD
BOTTOM VIEW
3