Club Car Pioneer 1200, Руководство по техническому обслуживанию

Страница: 238 / 360

FE350 ENGINE Crankshaft and Counterbalance
Page 13-40 2001 Pioneer 1200 Gasoline Vehicle Maintenance and Service Manual
13
8. Check the crankshaft alignment.
8.1. Place the crankshaft in an alignment jig.
8.2. Turn crankshaft (1) slowly and measure total indicated run-out at the location shown (Figure 13-
86, Page 13-40).
8.3. If total run-out exceeds 0.002 inch (0.05 mm), replace the crankshaft.
Undersized Connecting Rod
The connecting rod journal can accept an undersized connecting rod with a 1.3779 inches (35.0 mm) inside
diameter. Grinding the crankshaft is required before using the undersized connecting rod.
1. Have a reliable repair shop grind the crankshaft journal (A) (Figure 13-87, Page 13-40).
2. The final finishing dimensions are as follows (Figure 13-87, Page 13-40):
• (A) 1.4759 - 1.4763 inches (37.489 - 37.500 mm)
• (B) 0.110 - 0.126 inch (2.80 - 3.20 mm)
• (C) 1.1968 inches maximum (30.4 mm)
• (D) 1.2775 - 1.2814 inches (32.45 - 32.55 mm)
3. The connecting rod journal (A) must be concentric and cylindrical within 0.0002 inch (0.005 mm) at full
indicator reading (Figure 13-87, Page 13-40).
4. Finish should be very smooth. Use a super fine finishing stone.
OIL SCREEN
Oil Screen Removal
1. Remove the two bolts (1) to take out the oil screen plate (2) and the oil screen (3) (Figure 13-88, Page
13-41).
2. Clean the oil screen thoroughly with a high flash-point solvent, then dry the screen.
Oil Screen Installation
1. To install the oil screen, reverse the removal procedure.
2. Tighten bolts (1) to 30 in-lb (3.4 N·m).
Figure 13-86 Check Crankshaft Alignment Figure 13-87 Undersized Connecting Rod Journal
2
1
C
B
A
D