Club Car Pioneer 1200, Руководство по техническому обслуживанию

Страница: 301 / 360

UNITIZED TRANSAXLE WITH DIFFERENTIAL LOCK Component Disassembly
2001 Pioneer 1200 Gasoline Vehicle Maintenance and Service Manual Page 16-19
16
18.2. Remove the pivot arm (25) by pulling it through the wall to the interior of the case.
18.3. Use a small chisel or similar pointed instrument to pry the pivot arm oil seal (23) (Figure 16-40,
Page 16-16) out of the case (Figure 16-46, Page 16-18).
18.4. Remove the governor gear assembly (66 and 67) and flat washer (65) (Figure 16-48, Page 16-
20) by lightly tapping the gear shaft through the case wall, from the outside, with a hammer and
drift. See also Figure 16-49, Page 16-21.
COMPONENT DISASSEMBLY
Read DANGER and WARNING on page 16-1.
DIFFERENTIAL GEAR LOCK HOUSING DISASSEMBLY
1. Rotate the arm (99) and remove the differential lock cog (104) (Figure 16-47, Page 16-19).
2. Loosen but do not remove the differential lock arm retaining nut (101) and remove the arm (99) and
spring (98) from the differential lock shaft (95) (Figure 16-47, Page 16-19).
3. Remove the spacer (97) from the differential lock shaft (95) (Figure 16-47, Page 16-19).
4. Remove the shaft retaining screw (102) and washer (103) from the differential lock housing (Figure 16-
47, Page 16-19).
5. Press the shaft (95) toward the center of the differential lock housing and remove the shaft (95) from
the housing (94) (Figure 16-47, Page 16-19).
6. If necessary, gently pry the O-ring from the groove in the differential lock shaft with a small screwdriver
(Figure 16-73, Page 16-31).
Figure 16-47 Differential Lock Housing Disassembly
104
95
94
101
100
99
98
102
103
96
97