Club Car Pioneer 1200, Руководство по техническому обслуживанию

Страница: 143 / 360

TROUBLESHOOTING AND ELECTRICAL SYSTEM Test Procedures
2001 Pioneer 1200 Gasoline Vehicle Maintenance and Service Manual Page 11-25
11
2.1. Set the multimeter to 200
Ω
(ohms). Place the red (+) probe on the (A2) terminal of the starter/
generator and place the black (–) probe on the vehicle frame (Figure 11-24, Page 11-25). The
reading should be continuity. If the reading is incorrect, clean and tighten wire connections. If the
connections are good and the reading is incorrect, repair or replace the wire.
3. Check the engine ground strap.
3.1. Place the red (+) probe of the multimeter on the ground strap terminal end located on the oil filler
bracket on the engine (Figure 11-25, Page 11-25). Place the black (–) probe on the vehicle
frame. The reading should be continuity. If the reading is incorrect, clean and tighten wire connec-
tions. If the connections are good and the reading is incorrect, repair or replace the wire.
4. Check voltage regulator ground connection (at battery frame ground). Make sure it is clean and tight.
5. Check the battery ground cable.
5.1. A 6 gauge black wire connects the negative battery post to the frame. The frame connection should
be clean and tight. Visual inspection of the connection on the frame is very difficult. The best check
for tightness is to pull on the black wire. If the wire moves at the connection end, disassemble the
frame connection and clean the bolt, ring terminal, and nut. Reinstall the frame connection.
5.2. Set the multimeter to 200
Ω
(ohms). Place the red (+) probe on the unconnected end of the 6
gauge black wire, and place the black (–) probe on the vehicle frame (Figure 11-26, Page 11-25).
The reading should be continuity. If the reading is incorrect, check that terminal connections are
clean and tight. If the connections are good and the reading is incorrect, repair or replace the wire.
Figure 11-24 Test Starter/Generator Ground Strap Figure 11-25 Test Engine Ground Strap
Figure 11-26 Battery Ground Cable Test
F2
A2 TERMINAL
WIRE TO FRAME NEXT
TO BATTERY
Club Car
The engine ground
is attached to the
oil filler bracket,
and the frame i-beam.
Place black (–)
probe on
frame.
Disconnect the 6 gauge
black wire from the battery.
Place red (+) probe on
disconnected end of wire.
2m
20
m
200
m
2k
200
200
200 200
20
2
200
m
500
20k
200k
2000
k
Ω
Ω
1000
OFF
WAVETEK 5XL
V
V
V
A
! !
COM 200nA
MAX
1000 ---
750V
FUSED