Club Car Pioneer 1200, Руководство по техническому обслуживанию

Страница: 240 / 360

FE350 ENGINE Crankshaft and Counterbalance
Page 13-42 2001 Pioneer 1200 Gasoline Vehicle Maintenance and Service Manual
13
OIL SEALS
Oil seals are used on both ends of the crankshaft. Any time the crankshaft is removed from the seals, the
seals must be replaced with new ones.
Oil Seal Removal
Use an oil seal remover to press or drive the seal out of the casing.
Oil Seal Installation
NOTE: Never reuse an oil seal. Replace the oil seal with a new one.
1. Put a light coating of clean engine oil on the outside edge and the inner lip of the oil seal to assist instal-
lation.
2. Install all oil seals with their lips facing the center of the engine.
3. Using the 1.37 inch (35 mm) seal driver, press the oil seal into the flywheel side of the crankcase until it
is flush with the hole.
4. Using the 1.97 inch (50 mm) seal driver, press the oil seal into the crankcase cover until it is 0.157 inch
(4 mm) below the outside surface.
Plain Bearing Surface Inspection
Plain bearing surfaces are used for both ends of the camshaft and the flywheel end of the crankshaft.
1. Inspect the camshaft surfaces, one in the crankcase (3) (Figure 13-91, Page 13-41) and the other in
the crankcase cover (1) (Figure 13-92, Page 13-42). Using an inside micrometer or telescoping gauge,
measure the inside diameter of each bearing surface. If the inside diameter is greater than 0.9080 inch
(23.063 mm), replace the crankcase and/or the crankcase cover.
2. Inspect the crankshaft bearing surface (2) in the crankcase. Using an inside micrometer or telescoping
gauge, measure the inside diameter of the bearing surface. If the inside diameter is greater than 1.1841
inch (30.075 mm), replace the crankcase (Figure 13-91, Page 13-41).
Figure 13-92 Inspect Camshaft Bearing Surface
in Crankcase Cover
Figure 13-93 Crankshaft Assembly
1