Club Car Pioneer 1200, Руководство по техническому обслуживанию

Страница: 185 / 360

ELECTRICAL COMPONENTS Fuel/Hour Gauge
2001 Pioneer 1200 Gasoline Vehicle Maintenance and Service Manual Page 12-23
12
Oil Warning Light Removal
1. Disconnect the battery cables, negative cable (–) first (Figure 12-1, Page 12-2).
2. Remove the dash panel. See Key Switch Removal on page 12-15.
3. Disconnect the wires from the oil warning light (1) (Figure 12-23, Page 12-22). Do not allow wires to
touch.
4. Depress the retaining tabs and remove the light from the center dash.
Oil Warning Light Installation
1. Push a new unit into hole in dash until plastic tabs engage dash (Figure 12-23, Page 12-22).
2. Connect the two yellow wires from the wire harness to the oil warning light.
3. Install the dash in reverse order of removal.
4. Connect battery cables, positive cable first and tighten the terminals to 20 ft-lb (27.1 N·m). Coat termi-
nals with Battery Protector Spray (CCI 1014305).
FUEL/HOUR GAUGE
Read DANGER and WARNING on page 12-1.
Testing the Fuel/Hour Gauge
See Section 11, Test Procedure 26, Page 11-40, and Test Procedure 27, Page 11-41.
With the key switch in the OFF position, the fuel/hour gauge fields are blank. When the key switch is turned to
ON, both fields activate. The fuel gauge initially registers full for a brief moment before indicating the actual
fuel level.
The hour gauge displays the number of hours of use in increments of .1 hour, but does not record additional
time unless the key switch is in the ON position. When the hour gauge is recording, the hourglass icon at the
left of the field blinks slowly.
Fuel/Hour Gauge Removal
1. Disconnect the battery cables, negative cable (–) first (Figure 12-1, Page 12-2).
2. Remove the dash panel. See Key Switch Removal on page 12-15.
3. Disconnect the wires from the fuel/hour gauge (2) (Figure 12-23, Page 12-22). Do not allow wires to
touch.
4. Remove the two hex nuts (3) and lock washers (4) from the threaded studs on the back of the gauge.
Remove the mounting bracket (5) from the back side of the gauge and remove the gauge from the
dash.