Club Car 2007 XRT 800, Руководство по техническому обслуживанию

Страница: 138 / 516

TROUBLESHOOTING AND ELECTRICAL SYSTEM: 800 AND 810 GAS Test Procedures
Page 11-14 2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
11
TEST PROCEDURE 5 – KEY SWITCH (ACCESSORY TERMINAL)
See General Warning on page 1-1.
1. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in the NEUTRAL posi-
tion. Chock the wheels.
2. Disconnect the battery cables as instructed. See WARNING “To avoid unintentionally starting...” in
General Warning on page 1-2 .
3. Remove the instrument panel. See Key Switch Removal, Section 13, Page 13-14.
4. Ensure that the connector is connected correctly and is tight. If it is not, repair or replace as necessary.
5. Insert the key and turn the switch to the ON position. With the multimeter set to 200 ohms, place the red
(+) probe of the multimeter on the (B) terminal and the black (–) probe on the (L) terminal of the key switch
(Figure 11-9, Page 11-14) . The reading should be continuity. If the reading is incorrect, replace the key
switch. See Key Switch Removal, Section 13, Page 13-14.
Figure 11-9 Key Switch Test – Accessory Terminal Figure 11-10 Key Switch Test – Starter Circuit
Figure 11-11 Remove Solenoid Wires
Reading with key switch
in the ON position
2m
20
m
200
m
2k
200
200
200 200
20
2
200
m
500
20k
200k
2000
k
1000
OFF
WAVETEK 5XL
V
V
V
A
!
!
COM 200nA
MAX
1000 ---
750V
FUSED
M B
L
G
S
Reading with key switch
in the START position
2m
20
m
200
m
2k
200
200
200 200
20
2
200
m
500
20k
200k
2000
k
1000
OFF
WAVETEK 5XL
V
V
V
A
! !
COM 200nA
MAX
1000 ---
750V
FUSED
M B
L
G
S
6-GAUGE WHITE
WIRE ASSEMBLY
16-GAUGE
RED WIRE
ASSEMBLY
18-GAUGE
WHITE WIRE
ASSEMBLY
SOLENOID
ELECTRICAL
COMPONENT
BOX
COVER