Club Car 2007 XRT 800, Руководство по техническому обслуживанию, Страница: 66 / 516

ACCELERATOR AND BRAKE PEDAL GROUP Pedal Group Adjustment – Electric Vehicles
Page 5-16 2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
5
PEDAL GROUP ADJUSTMENT – ELECTRIC VEHICLES
See General Warning on page 1-1.
1. Disconnect the battery cables as instructed. See WARNING “To avoid unintentionally starting...” in
General Warning on page 1-2.
2. Adjust brake pedal height.
2.1. Chock wheels and release park brake. Lift rear of vehicle and place jack stands under the axle
tubes to support the vehicle.
2.2. To provide slack in the brake cables, loosen the equalizer retaining nuts (2 and 3) on the equalizer
rods (1) (Figure 5-20, Page 5-16) .
2.3. Loosen the brake stop jam nut (31), then relieve pedal pressure on the stop by pushing down
slightly on the pedal. Next, adjust the brake stop bumper (22) up or down (Figure 5-21, Page 5-16) .
Adjusting the bumper upward decreases distance between pedal and floorboard. Adjusting the
bumper downward increases distance between pedal and floorboard. Proper brake pedal height is
6 inches (15.2 cm)
(Figure 5-22, Page 5-16) .
2.4. Tighten the jam nut (31) to 8 ft-lb (9.5 N·m) (Figure 5-21, Page 5-16) .
Figure 5-20 Loosen Rear Brake Equalizer Rod Nuts
Figure 5-21 Brake Pedal Height Adjustment Figure 5-22 Brake Pedal Height Measurement
1 2
3
22
31
PA
RK
ST
OP
1 2
3
4
5
6
7
8
9
10 11
12
Correct pedal position
is 6 inches (15.2 cm)
from floor mat to back
of brake pedal.