Club Car 2007 XRT 800, Руководство по техническому обслуживанию

Страница: 212 / 516

ELECTRICAL COMPONENTS: 800 AND 810 GASOLINE VEHICLES Key Switch
Page 13-14 2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
13
4.1. Connect the 12-gauge red wire from the diode to the solenoid post with the fuse block and battery
red wires and tighten locknut (7) to 55 in-lb (6.2 N·m) (Figure 13-16, Page 13-13) .
4.2. Connect the 12-gauge white wire to the other large solenoid post, along with the red wire from the
voltage regulator and white wire from the starter/generator and tighten nut (7) to 55 in-lb (6.2 N·m).
5. Replace the electrical component box cover (6) and screw (5) and tighten the screw to 18 in-lb (2.0 N·m).
6. Connect the intake hose to the carburetor and secure the hose with the hose clamp.
7. Connect the battery cables, positive (+) cable first, and tighten the terminals to 144 in-lb (16.3 N·m). Coat
terminals with Battery Terminal Protector Spray (CCI P/N 1014305).
KEY SWITCH
See General Warning on page 1-1.
Testing the Key Switch
See Test Procedure 4, Section 11, Page 11-13. Also see Test Procedure 17 – Key Switch (Engine Kill
Circuit) on page 11-28.
Key Switch Removal
1. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in the NEUTRAL posi-
tion. Chock the wheels.
2. Disconnect the battery cables as instructed. See WARNING “To avoid unintentionally starting...” in
General Warning on page 1-2.
3. Remove the instrument panel.
3.1. Loosen seven Tuflok screws, but do not remove screws completely, as shown in Detail A
(Figure 13-18, Page 13-15) .
3.2. Remove Tuflok screws from instrument panel as shown in Detail B.
3.3. Pull forward on top of instrument panel to access back side of key switch.
3.4. Disconnect the wire connector from the key switch.
4. Remove the key switch.
4.1. Remove the key switch nut (1) (Figure 13-17, Page 13-14) .
4.2. Remove key switch (2) from back side of instrument panel.
Figure 13-17 Key Switch Removal
1
2