Club Car 2007 XRT 800, Руководство по техническому обслуживанию, Страница: 192 / 516

TROUBLESHOOTING AND ELECTRICAL SYSTEM: 850 GAS Test Procedures
Page 12-30 2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
12
TEST PROCEDURE 23 – NEUTRAL LOCKOUT SWITCH
See General Warning on page 1-1.
1. Remove the wires from the switch (Figure 12-30, Page 12-30) .
2. With switch in position 1:
2.1. Check for no continuity between terminals T1 and T2.
2.2. Check for continuity between terminals T2 and T3.
3. With switch in position 2:
3.1. Check for no continuity between terminals T2 and T3.
3.2. Check for continuity between terminals T1 and T2.
4. If switch:
4.1. does not work as stated in previous steps, replace switch.
4.2. does work as stated and the MAINTENANCE/OPERATE modes still do not work:
- Check the fuse.
- Check the limit switches.
- Check continuity of the wires involved.
TEST PROCEDURE 24 – BATTERY TEST (UNDER LOAD)
See General Warning on page 1-1.
NOTE: Keep the battery connected while performing this test procedure.
1. Place the Forward/Reverse handle in the NEUTRAL position and the neutral lockout switch in the MAIN-
TENANCE position. Chock the wheels.
2. Set a multimeter to 20 volts DC and place the red (+) probe on the F2 (white wire) terminal on the starter/
generator. Place the black (–) probe on the negative (–) battery post.
3. Turn the key switch to the ON position, leave the Forward/Reverse shifter in the NEUTRAL position and
press the accelerator pedal (with the accelerator pedal pressed, the battery is under load).
3.1. If the voltage reading is over 9.6 volts, with an electrolyte temperature of 70 °F (21 °C), check the
Figure 12-30 Neutral Lockout Switch Test – for Pedal-
Start Vehicles
Position 1 Position 2
Position 1 Position 2
ON ON
T2 - T3 T1 - T2
Toggle Position Operates:
Rear View of Switch
T1 T3 T2
(BLK) (BLK/
LT BLUE)
(BLK/YEL)