ELECTRICAL COMPONENTS: 800 AND 810 GASOLINE VEHICLES
Solenoid
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
Page 13-15
13
Key Switch Installation
1. Install the key switch in the dash in reverse order of removal. Tighten the key switch nut firmly.
Reconnect the wire connector to the key switch.
2. Install the instrument panel in reverse order of removal.
See Key Switch Removal on page 13-14.
3. Connect the battery cables, positive (+) cable first, and tighten the terminals to 144 in-lb (16.3 N·m). Coat
terminals with Battery Terminal Protector Spray (CCI P/N 1014305).
SOLENOID
See General Warning on page 1-1.
Testing the Solenoid
See Test Procedure 6, Section 11, Page 11-15.
Solenoid Removal
1. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in the NEUTRAL posi-
tion. Chock the wheels.
2. Disconnect the battery cables as instructed.
See WARNING “To avoid unintentionally starting...” in
General Warning on page 1-2.
3. Remove the air intake hose from the carburetor.
4. Remove electrical component box cover.
5. Disconnect all the wires from the solenoid.
6. Remove the two screws securing the solenoid in place.
Figure 13-18 Instrument Panel Removal
A
B
Содержание 2007 XRT 800
