Club Car 2007 XRT 800, Руководство по техническому обслуживанию, Страница: 175 / 516

TROUBLESHOOTING AND ELECTRICAL SYSTEM: 850 GAS Test Procedures
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual Page 12-13
12
4. Check voltage regulator ground connection (at battery frame ground). Make sure it is clean and tight.
5. Check the battery ground cable.
5.1. A 6-gauge black cable connects the negative (–) battery post to the frame. The frame connection
should be clean and tight. Visual inspection of the connection on the frame is very difficult. The best
check for tightness is to pull on the black cable. If the cable moves at the connection end, disas-
semble the frame connection and clean the bolt, ring terminal, and nut. Reinstall the frame con-
nection.
5.2. Set the multimeter to 200 ohms. Place the red (+) probe on the unconnected end of the 6-gauge
black cable, and place the black (–) probe on the vehicle frame (Figure 12-7, Page 12-13) . The
reading should be continuity. If the reading is incorrect, ensure that terminal connections are clean
and tight. If the connections are good and the reading is incorrect, repair or replace the cable.
TEST PROCEDURE 4 – KEY SWITCH (STARTER CIRCUIT)
See General Warning on page 1-1.
1. Disconnect the battery cables as instructed. See WARNING “To avoid unintentionally starting...” in
General Warning on page 1-2.
2. Remove the center dash assembly. See Key Switch Removal on page 14-12.
3. Ensure that the wires are connected correctly and are tight. If they are not, rewire or tighten as necessary.
4. Insert the key and turn the key to ON. Place the red (+) probe of the multimeter on the (2) terminal and
the black (–) probe on the (1) terminal of the key switch. The reading should be continuity. If the reading
is incorrect, replace the key switch
(Figure 12-8, Page 12-14) .
Figure 12-7 Battery Ground Cable Test
1. Disconnect the 6-gauge black wire from the battery. Place
red (+) probe on disconnected end of cable.
2. Place black (–) probe on frame.
2m
20
m
200
m
2k
200
200
200
200
20
2
200
m
500
20k
200k
2000
k
1000
OFF
WAVETEK 5XL
V
V
V
A
!
!
COM 200nA
MAX
1000 ---
750V
FUSED
200 OHM
SETTING
1
2