Club Car 2007 XRT 800, Руководство по техническому обслуживанию

Страница: 198 / 516

TROUBLESHOOTING AND ELECTRICAL SYSTEM: 850 GAS Test Procedures
Page 12-36 2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
12
2. Inspect wires at light bulb socket. Make sure wires are securely fastened to the contacts inside socket.
3. Remove the wire harness from the headlight (Figure 12-37, Page 12-36) .
4. Using a multimeter set to 20 volts DC, place the black (–) probe of multimeter into the black wire terminal
of the wire harness. Place the red (+) probe into the blue wire terminal.
5. Pull the light switch to the ON position. If the multimeter reads approximately 12 volts, replace the bulb.
6. If there is no voltage reading at the wire harness, check continuity of the 16-gauge blue wire from the
headlight to the light switch. Using a multimeter set to 20 volts DC, attach using an alligator clip, the black
(–) probe of multimeter onto the negative battery terminal and place the red (+) probe into the blue wire
terminal of the wire harness. If multimeter reading is approximately 12 volts, the blue wire has continuity.
7. Check continuity of the 16-gauge black wire from the headlight to the ground terminal. Using a multimeter
set to 20 volts DC, place the black (–) probe of multimeter into the black wire terminal of the wire harness
and attach using an alligator clip, the red (+) probe onto the positive battery terminal. If the multimeter
reading is approximately 12 volts, the black wire has continuity.
Figure 12-36 Voltage Limiter Circuit Test
Figure 12-37 Check Voltage to Headlight Socket
YELLOW
BLACK
LIGHT
SWITCH
FRAME
GROUND
VOLTAGE
LIMITER
BLUE
BLA
CK
BLA
CK
2m
20
m
200
m
2k
200
200
200 200
20
2
200
m
500
20k
200k
2000
k
1000
OFF
WAVETEK 5XL
V
V
V
A
! !
COM
200nA
MAX
1000 ---
750V
FUSED
BLACK WIRE
BLUE WIRE
LEFT
HEADLIGHT
WIRE HARNESS
2m
20
m
200
m
2k
200
200
200 200
20
2
200
m
500
20k
200k
2000
k
1000
OFF
WAVETEK 5XL
V
V
V
A
! !
COM 200nA
MAX
1000 ---
750V
FUSED