Club Car 2007 XRT 800, Руководство по техническому обслуживанию, Страница: 255 / 516

ELECTRICAL COMPONENTS: 850 GASOLINE VEHICLE Ignition Coil
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual Page 14-23
14
RPM Limiter Installation
1. Place the RPM limiter damper on the front of the RPM limiter mounting bracket (Figure 14-23,
Page 14-22) .
2. Place the RPM limiter on the damper squarely so that RPM limiter fits tightly against the damper.
3. Place the band over the RPM limiter and align the holes. Place the brown wire ring connector onto the
flange-head bolt and secure the left side of the band. Use another flange-head bolt to secure the other
side of the band. Make sure the band holds the RPM limiter securely in place. Tighten fasteners to 7 ft-
lb (9.5 N·m).
4. Connect black wire at the bullet connector to the white/black wire.
5. Connect battery cables, positive (+) cable first, and tighten hardware to 144 in-lb (16 N·m) (Figure 1-1,
Page 1-3) . Coat terminals with Battery Terminal Protector Spray (CCI P/N 1014305) to minimize corro-
sion.
6. Install the seat.
IGNITION COIL
See General Warning on page 1-1.
Testing the Ignition Coil
See Test Procedure 13 – Ignition Spark on page 12-20 and Test Procedure 15 – Ignition Coil on
page 12-21.
Ignition Coil Removal
1. Disconnect battery cables as instructed. See WARNING “To avoid unintentionally starting...” in Gen-
eral Warning on page 1-2.
2. Remove seat to access engine compartment. See Section 4 – Body and Trim.
3. Disconnect spark plug wire from the spark plug. See WARNING “To avoid unintentionally starting...”
in General Warning on page 1-2.
4. Remove the muffler. See Muffler Removal on page 17-1.
5. Cut the wire tie holding the wire harness to the stiffener (1) and remove the bolts (2) and nuts (3) securing
the stiffener to the mounting plate (4) (Figure 14-24, Page 14-24) .
6. Remove the pan-head bolts (5) securing the fan shroud (8) to the fan housing (9) (Figure 14-25,
Page 14-24) .
7. Loosen, but do not remove, the three bolts (6) attaching the fan housing as shown.
8. Remove the remaining four bolts (10) attaching the fan housing as shown (Figure 14-25, Page 14-24) ,
then while opening the housing, detach the spark plug wire grommet (4) from the housing (Figure 14-27,
Page 14-25) .
9. Disconnect the 18-gauge black wire (12) from the spade terminal on the ignition coil (11) and remove the
coil by removing two bolts (10) (Figure 14-26, Page 14-24) .