Club Car 2007 XRT 800, Руководство по техническому обслуживанию, Страница: 320 / 516

UNITIZED TRANSAXLE: 800/810 GASOLINE VEHICLES Unitized Transaxle Installation
Page 18-16 2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
18
16. Position shocks in the shock mounts and install cushions, mounting washers and nuts (Figure 18-42,
Page 18-16) . Tighten nuts until cushions expand to be the same diameter as the mounting washers.
17. Connect brake cables. See Brake Cable Installation, Section 6, Page 6-11.
18. Connect the engine kill switch wire (18-gauge white/black) to the bullet connector at the lower right front
of the engine (Figure 18-43, Page 18-16) .
19. Install three wire ties to secure the engine kill wire to the accelerator cable where they both route together
on the passenger side of the engine.
20. Connect the oil level sensor wire (18-gauge yellow) to the jumper wire (Figure 18-44, Page 18-16) .
21. Connect the 6-gauge white wire to the F2 post, the 6-gauge black ground wire to the A2 post and tighten
both wires to 48 in-lb (5.4 N·m). Connect the 16-gauge yellow wire to the DF post on the starter/generator
and tighten to 30 in-lb (3.4 N·m)
(Figure 18-45, Page 18-16) .
Figure 18-42 Shock Absorber Figure 18-43 Ignition Kill Wire
Figure 18-44 Oil Level Sensor Jumper wire Figure 18-45 Starter/Generator
WHITE/BLACK
WIRE
BLACK
WIRE
STARTER
GENERATOR
YELLOW
OIL SENDING
UNIT JUMPER
WIRE
F2
DF
F2
YELLOW WIRE
WHITE WIRE
GROUND WIRE