Club Car 2007 XRT 800, Руководство по техническому обслуживанию

Страница: 412 / 516

IQ DISPLAY MODULE (IQDM) AND IQDM-P DIAGNOSTICS Functions Menu
Page 22-12 2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
22
WRITE SETTINGS TO CONTROLLER
This function transfers all of the speed controller settings (except for “private speed mode”) from the handset
to the vehicle speed controller. This enables the trained technician to “clone” a speed controller. Once the
speed controller settings have been transferred to the handset, the technician can then connect the handset
to another vehicle and transfer the stored settings into the speed controller.
Speed Controller Cloning – Transferring Settings from the Handset to the Vehicle
1. Perform this procedure with a handset that has the desired speed controller settings. See Speed Con-
troller Cloning – Transferring Settings from the Vehicle to the Handset on page 22-11.
2. Locate a vehicle that does not have the desired speed controller settings.
3. Turn the key switch to the OFF position, place the Forward/Reverse handle in the NEUTRAL position,
and lock the park brake.
4. Plug the handset into the vehicle.
4.1. Connect one end of the cable to the jack located on the bottom of the handset.
4.2. Connect the cable adaptor to the IQDM cable.
4.3. Remove the dust cap from the IQDM jack.
4.4. Align the keyed portion of the plug with the IQDM jack and connect the plug to the jack
(Figure 22-4, Page 22-12 or Figure 22-5, Page 22-12).
5. Scroll to the functions menu and select.
Figure 22-4 Handset Executing Figure 22-5 Confirmation Message
2
3
Executing...
1
2
3
All Controller Settings
Saved in Programmer.
OK (+) OK (+)
1