Cisco UCS C480 M5, Инструкция по установке и обслуживанию

Страница: 22 / 164

Step 5 Open the hinged flap at the top of each plastic cable guide and route your cables through the cable guides as desired.
Reversing the Cable Management Arm (Optional)
Step 1
Rotate the entire CMA assembly 180 degrees, left-to-right. The plastic cable guides must remain pointing upward.
Step 2 Flip the tabs at the ends of the CMA arms so that they point toward the rear of the server.
Step 3 Pivot the tab that is at the end of the width-adjustment slider. Depress and hold the metal button on the outside of the tab
and pivot the tab 180 degrees so that it points toward the rear of the server.
Figure 10: Reversing the CMA
Metal button on outside of tab 2 CMA tab on end of width-adjustment slider 1
Initial Server Setup
This section describes how to power on the server, assign an IP address, and connect to server management
when using the server in standalone mode. To use the server in Cisco UCS Manager integration, specific
cabling and settings are required. See
Installation For Cisco UCS Manager Integration, on page 161 .
Note
Cisco UCS C480 M5 Server Installation and Service Guide
20
Installing the Server
Reversing the Cable Management Arm (Optional)