Cisco ONS 15310-CL, Руководство по устранению неисправностей

Страница: 290 / 332

1-14
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
78-17235-01
Chapter 1 Error Messages
EID-2218 Bandwidth must be between {0} and {1} percent. The bandwidth must be within the specified
parameters.
EID-2219 Protection operation failed, XC loopback is applied on
cross-connection. As the protection operation failed, a
cross-connect (XC) loopback will be
applied on cross-connection.
EID-2220 The tunnel status is PARTIAL. CTC will not be able to change
it. Please try again later Refer to the error message text.
EID-2221 Cannot find a valid route for the unprotected to {0} upgrade
request. Refer to the error message text.
EID-2222 One or more of the following nodes are currently part of a
4-fiber {0}. Only a single 4-fiber {0} is supported per node.
{1}
The nodes, specified by {1}, are already
part of a 4-fiber BLSR/MS-SPRing type
(specified by {0}).
EID-2223 Only one circuit can be upgraded at a time. Refer to the error message text.
EID-2224 This link may not be included as it terminates on the source. Refer to the error message text.
EID-2225 No valid signal while trying to complete the roll. (0) Roll can be completed only when a valid
signal is detected. If not, the roll completion
may result in an error.
EID-2226 Circuit roll failure.
{0}
Refer to the error message text.
EID-2320 This VCAT circuit does not support deletion of its member
circuits. You can not delete a circuit that is a member
of VCAT circuit.
EID-2321 Error deleting member circuits.
{0}
Refer to the error message text.
WID-2322 Not all cross-connects from selected circuits could be merged
into the current circuit. They may appear as partial circuits. Refer to the warning message text.
EID-2323 Circuit roll failure.
Bridge and roll is not supported on a monitor circuit.
A monitor circuit does not support Bridge
and Roll.
EID-2324 Circuit upgrade error.
{0}
Refer to the error message text.
EID-2325 You have failed {0} times to unlock this session. CTC will exit
after you click OK or close this dialog box. The maximum amount of attempts to
unlock this session has been reached.
WID-2326 Currently, CTC does not support bridge and roll on circuits that
are entirely created by TL1. To continue with bridge and roll in
CTC, selected circuits must be upgraded.
OK to upgrade selected circuits and continue bridge and roll
operation?
Refer to the warning message text.
WID-2327 Currently, CTC does not support bridge and roll on circuits that
are partially created by TL1. To continue with bridge and roll
in CTC, selected circuits must be upgraded.
OK to upgrade selected circuits and continue bridge and roll
operation?
Refer to the warning message text.
Table 1-1 Error Messages (continued)
Error Warning
ID
Error Warning Message Description