Chapter 10 Configuring the Sensor Using the CLI
IDSM-2 Configuration Tasks
10-108
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
78-15597-02
Configuration Commands
The following configuration commands are all performed in either global
configuration mode, interface configuration mode, or VACL configuration
submode:
•
Global configuration mode
–
clock calendar valid
Sets the current calendar time as the switch time on bootup.
–
clock summer-time zone recurring
Sets the switch to use the summertime settings.
–
clock timezone zone offset
Sets the timezone for the switch/IDSM-2.
–
intrusion-detection module module_number management-port
access-vlan access_vlan_number
Configures the access vlan for the IDSM-2 command and control port.
–
intrusion-detection module module_number data-port
data_port_number capture allowed-vlan allowed_capture_vlan(s)
Configures the VLAN(s) for VACL capture.
–
intrusion-detection module module_number data-port
data_port_number capture
Enables VACL capture for the specified IDSM-2 data port.
–
ip access-list extended word
Creates access lists for use in the VACL maps.
–
monitor session session {destination {interface interface
interface-number} [ , | -] {vlan vlan-id}}
Sets the destination for a SPAN session.
–
monitor session session {source {interface interface interface-number}
| {vlan vlan-id}} [ , | - | rx | tx | both]
Sets the sources for a SPAN session.
–
no power enable module slot_number
Shuts down the IDSM-2 and removes power.
Содержание IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor
Страница 4: ......
Страница 450: ...Appendix B Troubleshooting ...