Chevrolet 70 1969 Series, Руководство по ремонту

Страница: 63 / 913

CAB A N D BODY M OUNTINGS 1-36
N O T E : Whenever torsion bar is in­
operative, cab must be supported safely.
Attaching bolts at front pivot mountings should
be checked at regular intervals for tightness. Loose
mountings will allow shifting of cab and eventual
failure of other items connecting cab to chassis.
Front pivot mountings have fittings for lubrication
purposes. Lubricate as directed under LU B R IC A ­
T IO N (SEC. 0) of this manual.
Rear mounting has positive locking mechan­
ism to retain cab in normal operating position in
relation to chassis frame. The rear mounting also
includes an addition;
Tightness of cal
ed by shortening or lengthening catch
After adjusting rod
Cab hold-down
lubrication fitting.
A check link if
mounting (see inset
tance cab can be tilted forward and a atom;
locks the cab in the full-tilt position.
Cht
must be released before cab mao
be ret
a.
normal operating noouum.
n !>i; -
elpi'tbe
f 'm i
til:!.
SEATS
CLEANING SEAT UPHOLSTERY
Use mild soap and lukewarm water and a stiff
bristle brush to clean upholstery. Mild synthetic
detergents may be used in place of soap. Rinse
thoroughly and dry after cleaning.
rfu i Attaching Studs
(Stud Nuts Accessible
fro n t
Under Cab)
Figure S — Driver’s Seat M ounting a nd Adjustment
C A U T IO N : Do no!
benzene,
acetone or any
tone solvents. These so 1
ing
agents of u|
resistance to cr,
SEAT ADJUSTMENT
Driver's seat (fig.
and "aft" adjustment
o r
, v .»■ v.":
side of seat to disr «p'ag«:>
j
SEAT TRACK
REPLACEMENT
(Refer
k- F lsv re h)
1. T ilt cab forw ard, nw n rviu-.rve v-.ur
and washers
to seat riser
m: n
2. Lower cab to ':pi>niir;;:
seat assembly front cafe,
3. I F I':",:
assembl
bly
.
4. Reverse uv a t s v . n
■ ■ ■ ■ ■ ■ '’..
.
track assembiy.
DOORS
Component sub-assemblies of cab doors, such
as window regulator, door lock, remote control,
vent window, and door window can be replaced
without necessity of removing door from cab. Doors
can be removed, however, without prior removal of
above components. Removal and installation of
door window glass is described later in this section.
DOOR REPLACEMENT
R E M O V A L
1. With the aid of an assistant to support
weight of door, remove six screws which attach
hinge straps to door. N O T E : Access to one cap
screw at door upper hinge is gained by removing
plug from door
k i w i
remove plug.
2. Carefully rernov*
IN S T A L L A T IO N
Attach door to hinge straps with six
Adjust door in cab opening as instructed
"Door Adjustments."
DOOR ADJUSTMENTS
Doors can be adjuster,
ance in the cab
latching. Door alignment
rf-SO '---.A