Chevrolet 70 1969 Series, Руководство по ремонту

Страница: 53 / 913

CAB
AN D
BO D Y
M OU NTINGS
1-26
Figure 26— Door W indow Glass Assembly
to permit installation in any vehicle without special
tools.
d. Cut new piece of channel filler slightly
longer than channel. Position filler (soapstone side
away from glass) around glass.
e. Brush inside of channel freely with light
engine oil.
f. Press channel on filler and glass until firm­
ly seated,
IM P O R T A N T : Make sure channel ends are
equal distance from edge of glass (fig. 26) and that
regulator arm slot in channel, is facing the right
direction in respect to rounded and squared corn­
ers at upper edge of glass. Trim off excess filler
material along channel and at ends.
IN S T A L L A T IO N
1. If glass run channel was removed from
door framing, install channel by pressing run
channel into place around door frame.
2. If the glass horizontal seal strips were
removed from door, press new seal strips into
position making sure all strip attaching clips are
fully engaged.
3. Lower the door window assembly into door
(fig. 25).
4. Engage glass channel on the roller of reg­
ulator arm. N O T E : Regulator arm should be in
the window two-thirds closed position.
5. Install vent assembly as directed under
"Door Vent Window Assembly Replacement."
6. Check operation of vent assembly and win­
dow raising and lowering action for possible binding.
Figure 27— Replacing Door W indow Glass Regulator
DOOR W IN D O W REGULATOR
REPLACEMENT
N O T E : To replace regulator, it is first neces­
sary to remove the door window assembly and the
vent window assembly as directed previously under
"Door Window Glass Replacement."
1. Remove regulator handle.
2. Remove four screws which attach regulator
to door inner panel.
RUN
CHANNEL
Figure 28— Installing W indow
Gloss
Channel Run
CHEVROLET SERIES 70-80 H EAVY DUTY TRUCK SH O P M A N U A L