CareFusion IVAC P6000, Техническое и сервисное руководство

Страница: 20 / 106

Configuration and Calibration
P7000, P6000, TIVA, TCI & TIVA 20/106 1000SM00012 Issue 8
The calibration procedure for each of the four sensors within the pumps are described in this section. Calibration is only
necessary if in testing, the sensor performs outside of specification or if a full memory clear has been carried out (in
which case all calibration stages must be completed). Refer to Chapter 3, 'Routine Maintenance' for test procedures.
Syringe Size Calibration (243)
Calibration tools required: 1000TG00010 (50ml Spacer A) and 1000TG00011 (100ml Spacer B)
Calibration procedure:

Enter the access code
243
.

Fit calibration tool into position on pump as shown below in Steps 1-3 and close the clamp. At each step,
CAL
is
displayed if value is within tolerances.
Press
CAL
softkey to store calibration point.
Notes
:
1) If
CAL
is not displayed, check for correct positioning of calibration tool. If calibration cannot be performed, repairs
to pump may be necessary.
2) The calibration values shown on the pump displays are for illustrative purposes only.

Power down to complete the calibration sequence (Step 4).
Analysis of process variation shows that a 2 point calibration system is not always sufficient to
define the syringe size detection system across the 5ml to 100ml range. The effect is only observed
when using 100ml syringes, which may not be recognised. If this occurs, the pump should be
recalibrated using a 3 point calibration.
Calibration Procedures
Step 2
Step 4 Step 3
Step 1
Confirmatory Check - To confirm that the syringe sizing calibration has been performed correctly,
select a syringe (preferably 50ml), load and confirm the correct syringe type. Check that the
correct syringe size is detected and displayed.