Canon laser Shot LBP 3300, Руководство пользователя

Страница: 331 / 414

6-26
Optional Accessor
ies
6
Network Board
14
Close the expansion slot cover.
Setting the Network Board
The default value of the network board is set at "Auto detect". Usually, you do not
need to change the setting, since the transmission speed and transfer mode of
10BASE-T/100BASE-TX are detected automatically. If the printer cannot
communicate with other devices on the network, set the DIP switches on the
network board. Before setting the DIP switches, turn the printer OFF, then remove
the network board. A Phillips screwdriver is required for removing the network
board. Have a screwdriver ready in advance that matches the size of the screws.
Set the DIP switches according to the transmission speed of the connected network
as follows.
IMPORTANT
When setting the DIP switches, be careful not to damage the main board with the tip of a
ball-point pen etc. Do not use a sharp object such as a mechanical pencil.
ERR LNK 100
NB-C1
ON
OFF
OFF
1 2 3 4
DIP switches
* Shown above is the
Auto detect setting
(default setting)