Campbell CPEC300, Руководство по эксплуатации продукта

Страница: 43 / 175

CPEC300/306/310 Closed-Path Eddy-Covariance Systems
34
FIGURE 5-11. CPEC300 splicing switches
Replace the cap on the CPEC306 and CPEC310 enclosure feedthrough. Gently
bend the cables back as you slide the cap on and rotate the cap to minimize the
space around the cables. Tighten the thumbscrew to further relieve strain on the
cable. This will also minimize air infiltration and extend the life of the
enclosure desiccant packs.
In very humid conditions or locations with insects and small
rodents it may be helpful to seal the cable feedthrough with
plumber’s putty.
6. Configure the
EasyFlux DL
Program
EasyFlux
™
DL CR6CP is a CRBasic program that enables a CR6 datalogger to
collect fully corrected fluxes of CO
2
, latent heat (H
2
O), sensible heat, ground
surface heat (optional), and momentum from any CPEC300-series system with
optional GPS and energy balance sensors. The program processes EC data
using commonly used corrections in the scientific literature. Because the
number of analog channels on the CR6 is limited, the program also supports
the addition of a CDM-A116 analog channel expansion module, which allows
a full suite of energy balance sensors, thus enabling the program to calculate
the ground surface heat flux and energy closure.
Specifically, the program supports data collection and processing from the
following systems and sensors.
NOTE