SECTION 10 MANUAL KEY
®
making
since 1986
water work
1. Manual Water a Station
From the MANUAL IRRIGATION screen (Figure
10.2).
1.
Press the
PLUS
or
MINUS
keys
to change the station number.
2.
Press the
MANUAL WATER
STATION # FOR #.## MINS
Menu key.
The IRRIGATION FOR STATION # screen is
displayed (Figure 10.3).
Details
1.9 Min of 4.0 Min Cycle
IRRIGATION for STATION 1
Manually Watering ( mv open-pump off )
Figure 10.3
Note:
Pressing the
DETAILS
Menu key will
take you to the IRRIGATION DETAILS screen
where you can view, or clear the station.
(See Section 6 REPORTS / IRRIGATION
DETAILS).
2. Manual Water a Program
From the MANUAL IRRIGATION screen
(Figure 10.2).
1.
Press the
PLUS
or
MINUS
keys
to change the program selection.
2.
Press the
MANUAL WATER
PROG # STATIONS
Menu key
to activate watering of all stations
for selected program.
The IRRIGATION FOR STATION # screen will
appear for each station as it irrigates (Figure 10.3).
3. Cycle and Soak during Manual
From the MANUAL IRRIGATION screen
(Figure 10.2).
1.
Press the
PLUS
or
MINUS
keys to change the CYCLE &
SOAK DURING MANUAL
setting (Figure 10.2).
Note:
This will use the Soak-in-Time and minutes
per cycle setting for each station individually. IF “NO”
then it will water the Total Minutes without soaking.
THIS CONCLUDES THE MANUAL WATERING
SECTION
B. TEST
The Test section of the controller is used to:
•
Learn expected flow rates at a station.
•
Test an individual station.
•
Test station moisture sensors
(If enabled)
.
From the MANUAL MENU screen (Figure 10.1).
1.
Press the
TEST
Menu key.
The VALVE TESTING screen is displayed
(Figure 10.4)
Test Station 1 for 2.0 minutes
Test Station 1 for Moisture Sensor
( MASTER )
VALVE TESTING
Learn the Expected at Station 1
Figure 10.4
1. Learn the Expected at a Station
The Learn expected option on the controller will
learn the expected flow rate for each station on each
program selected.
From the VALVE TESTING screen (Figure 10.4)
