Brocade Communications Systems Fabric OS v7.0.1, Справочник по командам

Страница: 650 / 1132

624 Fabric OS Command Reference
53-1001764-01
portCfg
22
FUNCTION
Commands supported only on the Brocade FR4-18i blade.
SYNOPSIS
portcfg action [ slot /] ge _ port [ if_action ] arguments
DESCRIPTION
Use this command to manage configuration parameters for ports and Gigabit Ethernet (GbE) ports on the
Brocade FR4-18i FC blade. The following commands are exclusive to this blade.
•
portcfg arp - Add and delete address resolution protocol (ARP) entries. Flush ARP table.
•
portcfg fciptunnel - Create, modify, and delete Fibre Channel over IP (FCIP) tunnels.
-
Delete, reset, and modify QoS mappings on an existing tunnel.
-
Create or modify a tunnel with VLAN tagging and Class of Service (CoS).
-
Create or modify a tunnel with Tape read/write Pipelining enabled or disabled.
-
Create or modify a tunnel with Byte Streaming enabled or disabled.
•
portcfg fastwrite - Configure the FC port for FC FastWrite.
•
portcfg ficon - Manage FICON emulation in an FCIP tunnel.
OPERANDS
This command has the following operands:
slot
For bladed systems only, specifies the slot number of the port to be configured,
followed by a slash (/).
ge_ port
Specifies the number of the port to be configured, relative to its slot for bladed
systems. The GbE ports on the Brocade FR4-18i are numbered ge0 - ge1. Use
the
switchShow command for a list of valid ports.
arp
Optionally adds entries to the address resolution protocol (ARP) table or deletes
entries from ARP table. Can also be used to flush the entire table. The syntax for
portcfg arp is as follows:
portcfg arp [ slot /][ ge ] port options arguments
Valid options and arguments for arp include the following:
add ipaddr macaddr
Adds a static ARP entry to the ARP table. Specify an IP address and a MAC
address for each entry. Use
portShow arp with the -lmac option to get the MAC
address.
delete ipaddr
Deletes a static ARP entry from the ARP table. Only the IP address must be
specified to delete the entry.
flush
Flushes the ARP table. Only dynamic entries can be flushed, static entries cannot
be cleared.
fciptunnel
Creates, modifies, or deletes a Fibre Channel over IP (FCIP) tunnel. You can
configure up to a maximum of eight FCIP tunnels per GbE port. The syntax for
portCfg fciptunnel is as follows:
portcfg fciptunnel [ slot /][ ge ] port options arguments [ optional_arguments ]