Sending Results to the Host
Introduction
IMMAGE 800 Operations Manual A11403
Results Recall
September 2016
Page 8-13
8
Sending Results to the Host
Introduction
Results from the IMMAGE 800 are automatically sent to the host computer when the
autosend is enabled in Host Communications setup.
Results can be sent manually to the host computer whether autosend is enabled or
disabled.
Manually Sending Results to the Host
Follow the steps below to manually send results to the host computer.
Additional Information
Refer to CHAPTER 5,
System Setup
, Host Communications Setup, for information
about autosend.
Step
Action
1
From the Recall Results By screen, select a single sample or range of
samples to send to the host computer.
2
To...
select...
send results to the host
computer without displaying
them,
Send to Host [F8]
.
display results and send them
to the host computer,
Display Results [F1]
, then
Send to
Host [F6]
.
Select
Prev Sample [F9]
or
Next
Sample [F10]
to display other
samples if more than one sample was
recalled.
Select
Send to Host [F6]
for each
sample displayed to send it to the host
computer.
3
Select
Cancel Send [F4]
to stop sending results to the host.
