4-7
Uploading a Job from the Panel
Overview
This section describes uploading an existing job from an AUTOPULSE Z-28 FACP to the
service PC for editing. An upload occurs over a serial link running between the panel and the
PC. Follow the steps outlined in the following sections to link the PC and panel and upload the
job.
Note: If the panel containing the job that you want to upload is on a network, you can upload
the job, but you cannot edit the job’s attributes (i.e., change system options, add points, etc.).
Step 1. Set Panel and PC
Baud Rates to 19,200
1.
Set switches SW1 and SW2 to the positions shown in Figure 4-8. These positions enable
a baud rate of 19,200 on the AUTOPULSE Z-28 FACP.
Figure 4-8. Switch Position for 19,200 Baud
2.
Start the AUTOPULSE Z-28 Programmer application.
3.
Click on the Transfer menu and select Settings. A dialog similar to the one shown in
Figure 4-9 appears.
Figure 4-9. Setting PC Transfer Rate to 19,200
Continued on next page
Black indicates switch position
19,200
Black indicates switch position.
