Hydro Cat 5015B
Service Manual
WHEEL DRIVE SYSTEM
________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
DIFFERENTIAL OIL LEVEL CHECK
The dipstick for the differential oil is located under the operator’s seat. Add 90W gear lube if necessary, to
bring the oil level up to the indentation in the dipstick (approximately 1 inch / 2.57 cm from the tip).
________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
WHEEL MOTOR - CARBON BRUSH INSPECTION
The carbon brushes in the wheel motor should be checked every 1000 hours of operation. To check the
carbon brushes, tip the operator’s seat forward and carefully remove one of the brushes from the motor. If the
brush is worn to a length of 3/8 inch (10 mm) or less, remove the motor from the machine and replace all the
brushes.
________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
WHEEL MOTOR REMOVAL
1
Remove the solution tank. (See Solution System chapter for instructions).
FIGURE 3
A
B
C
#21
#22
2
See Figure 3. Move the machine so
the master link on chain coupler “B”
is facing toward the front of the
machine.
3
Disconnect the battery connector
(inside the right-rear door).
4
Remove the master link and the
chain from the coupler.
5
Lift the operator’s seat and discon-
nect wires #21 & #22 from the motor.
Note: Use a wrench to hold the inner nut
on each terminal while loosening the outer
nut.
6
Remove the four “A” bolts and work
the motor out of the machine.
57