Page
64
of
125
Spindle IP Addresses
: The number of spindles
listed depends on the number of spindles
enabled. Add the IP addresses of the slave
spindles to add them to the spindle network.
PSets: Synchronizing Stages
When setting up a PSet, the Sync stage is
available to synchronize spindle rundowns.
Sync stages allows each spindle to pause
between stages and wait for other spindles to
reach the same stage before proceeding.
For example, a PSet set up to perform TC,
Sync, Unfasten, Sync, TC will ensure that all
spindles reach the target torque before going
to the unfasten stage. At that time, all spindles
will unfasten to the desired angle and will not
proceed until each spindle has completed
that stage before running down to the final
torque. The rundown curve for this type of
PSet is shown with four spindles.
PS
ET WITH
S
YNC
E
XAMPLE
TC,
S
YNC
,
U
NFASTEN
,
TC
