Page
47
of
125
4.5.1.6 Disassembly
Timeout (sec):
Total amount of time, in seconds, after
throttle is depressed that tool will operate.
Max Speed (RPM):
Maximum speed of the Output
spindle.
Acceleration:
Rate at which tool is set to ramp up to
maximum RPM.
Report Disassembly:
If enabled, disassembly events will
be reported and logged.
Threshold Torque:
Disassembly will be reported only if
this torque value is reached. This is entered as a
positive value.
Torque Units:
Units for the Disassembly Threshold Torque
When a disassembly event is reported:
The disassembly will be displayed on the run screens
and logged in the rundown record, containing the
following:
•
Overall evaluation will be marked as ‘Disassembled’
Peak torque during the disassembly (torque shown
as negative).
•
Peak overall angle during the disassembly (angle
shown as negative).
•
Curve data from the disassembly
•
Parameters from the current PSet selected
•
Fastening events from the disassembly.
All of the controller’s status LEDs will be turned OFF. The LED display will show peak torque and
angle as negative
IO Considerations:
When disassembling, all assignable IO outputs that report rundown status will remain in the state
from the last fastening cycle. This includes:
Ok and Nok signals
Torque/Angle high or low signals
Torque and Angle Values
All assignable IO outputs reporting a fasting events will not change state during the disassembly.
This includes:
Fastening Complete
In Cycle
Fastening Stopped
Fastening Aborted
NOTE:
When the tool is placed into disassembly mode, all of the tool’s LEDs flash and the Horn
beeps. This will continue until the tool is placed back into fastening mode.
