Page
45
of
125
MFB:
Pressing MFB button on tool (regardless of MFB configuration).
Unlock Torque:
If Unlock Mode is set to “Reverse and Unlock Torque”, this torque value must be
exceeded when tool is in the disassembly direction in order to unlock tool.
4.5.1.2 Buzzer
Buzzer Enable:
When enabled, the Buzzer will beep when a rundown is rejected.
If a rundown is rejected, the beeping can be stopped by making a successful rundown or by
using the MFB.
4.5.1.3 Headlight
Headlight Enable:
Enables or Disables the Headlight (pistol style tools only).
4.5.1.4 Start Input Configuration
START FROM I/O:
Start tool through I/O from external source.
START FROM TOOL BUTTTONS
: Normal operating condition:
Tool lever and MFB control tool operation.
START FROM MASTER TOOL
Tool Throttle Configuration:
Four options are available:
•
Lever or PTS (Push to Start): This the default configuration.
Pressing either the Lever or PTS will start the tool.
•
Lever and PTS (Push to Start): Both the Lever and the PTS
need to be pressed in order to start the tool.
•
Lever: Only the Lever will start the tool.
•
PTS: Only the PTS will start the tool.
Latching Options:
•
Not Latched: Start Input is not latched.
•
Latch on Time: Start Input latches if lever is pressed for a set
time.
•
Latch on MFB: Latches on the following sequence:
o
Press and hold lever.
o
Press MFB. While lever is still being held down.
o
Release the lever.
o
Release the MFB.
o
Latch Hold Time: Amount of time (seconds) the lever
needs to be depressed to latch throttle (if Latched on
Time is selected above).
NOTE:
Throttle will unlatch automatically at the end of the rundown or when the lever is
repressed. If the tool is installed with dual levers requiring two-handed operation, the above
Start Input Configuration settings will be ignored (see Dual Lever Two Handed Tools section).
