Page
66
of
125
4.6.1 Tool Setup
Allows user to make changes to Tool Setup.
Model Number:
Tool model number of tool connected to
controller.
Tool ID:
Serial Number of current tool connected to controller.
Cycle Count:
Total number of cycles since last reset.
Multiplier:
Configures tool to include gearing added to the base
model. Units: Gear Ratio * 100 (Example: Adding a multiplier with
a gear ratio of 5:1, Multiplier setting = 5).
Gear Inversion:
1= tool Output rotates same direction as motor
and -1= tool Output rotates in opposite direction as motor.
Tube Nut Parameters
Obstruction Torque (in*Lb):
First 90° degrees of rotation in the
fastening direction. Cycle will be aborted if this torque is
exceeded. If the tool rotates 90° degrees and stops without any
obstruction, the value is too low.
Open Loop (in*Lb):
After reaching the open position, this is the “hold at Home” torque
preventing socket from bouncing to a partially closed position. This torque should be set to a
value slightly less than the tube nut Home torque.
Home (in*Lb):
In the reverse direction, reaching this torque indicates to controller that
socket is in open position. If socket does not attempt to return to open position this value is too
low. AcraDyne recommends starting at approximately 12 in-lbs.
4.6.2 Service Log
Service Parameters are stored in memory of tool and can be
viewed in this screen. The ‘Next Service Cycle’ or ‘Next
Service Date’ will turn red if value entered is exceeded.
