Ace ACE-3205, Инструкция по установке и эксплуатации

Страница: 96 / 418

Chapter 4 Configuration Installation and Operation Manual
4-6 Configuring for Management ACE-3105, ACE-3205 Ver. 5.2
³
To configure an out-of-band Ethernet control port:
1. From the Configuration menu, select Physical Layer.
The Physical Layer menu appears (see
Figure 4-32
).
2. Select Port.
The Port menu appears (see
Figure 4-33
).
3. Select Ethernet.
The Ethernet menu appears (see
Figure 4-34
).
4. Select/enter the following parameters:
Table 4-4. Management Ethernet Port Configuration
Parameter Required Value
Port number 2
Port activation Enable
Auto
negotiation Enable
Max capacity
advertised 100BaseT Full Duplex
Rate limiter Disable
5. Press S to save.
Ethernet port No. 2 is now physically configured for out-of-band
management. The manager IP or the router interface must be set
separately (for more information, see
Defining the IP Address of Network
Managers and Configuring the Router Interface ).
Configuring Management Parameters
ACE-3105, ACE-3205 can be managed by a network management station (NMS).
In order to establish proper connection between the unit and the NMS, it is
necessary to configure the router interface parameters, IP address of network
managers, alarm traps, SNMPv3 parameters (if applicable) read/write
communities, and define at least one network manager. In addition, you can view
and edit the general device information.
•
Viewing device information
• Configuring router parameters
•
Defining the IP address of network managers
• Configuring remote management access.
These functions are available from the Management menu.