Ace ACE-3205, Инструкция по установке и эксплуатации

Страница: 203 / 418

Installation and Operation Manual Chapter 4 Configuration
ACE-3105, ACE-3205 Ver. 5.2 Configuring for Operation 4-113
Parameter Description Possible Values
•
Cannot be modified dynamically (on the fly).
• The ingress tunnel's traffic descriptor must be
configured in advance.
• The ingress tunnel provisioning mode (manual
or LDP-driven; see
Figure 4-72 ) must be the
same as the egress tunnel provisioning mode.
Egress tunnel
index Index of the egress tunnel definition for this PW.
A value of 0 means that the tunnel label is not
used.
Note:
• Relevant only for MPLS-based PSNs and only if
the PW subtype is data or clock distribution
(not visible for clock recovery).
• Cannot be modified dynamically (on the fly).
• The egress tunnel's traffic descriptor must be
configured in advance.
• The egress tunnel provisioning mode (manual
or LDP-driven) must be the same as the
ingress tunnel provisioning mode.
• If the provisioning mode is LDP-driven, the
peer number of the Egress Tunnel menu (see
Figure 4-73 ) must be the same as the peer
number in the PW General Parameters menu
(see
Figure 4-78 ).
0 or a configurable
egress tunnel index
Default: 0
EXP bits The required value for the EXP bits to be used on
the PW label and the tunnel label.
Note: Visible only for MPLS-based PSNs (MPLS,
MPLSoIP, MPLSoGRE) and only if the PW subtype
is data or clock distribution.
0–7
VLAN tag Enable or disable VLAN tagging on every
transmitted packet.
Note: Cannot be modified dynamically (on the
fly).
Enable
Disable
Default: as configured
for the matching
router interface
VLAN ID The VLAN ID that is carried on every transmitted
packet of this PW.
Note: Visible only if VLAN tagging is enabled.
0–4094
Default: as configured
for the matching
router interface
VLAN priority The VLAN priority that is attached to every
transmitted packet of this PW.
Note: Visible only if VLAN tagging is enabled.
0–7
Default: 0