Ace ACE-3205, Инструкция по установке и эксплуатации

Страница: 319 / 418

Installation and Operation Manual Chapter 6 Monitoring and Diagnostics
ACE-3105, ACE-3205 Ver. 5.2 Troubleshooting 6-81
ACE-3205 – RAD Data Communications
Diagnostics> Applications> IP> Trace Route
1. Destination IP address ... (100.10.151.201)
2. Start
>
Please select item <1 to 2>
ESC-previous menu; !-main menu; &-exit
Figure 6-68. Trace Route Menu
Table 6-66. Trace Route Options
Parameter Description Possible Values
Destination IP
address Specify the destination IP address towards
which the trace-route packets are to be
sent 0.0.0.0–
255.255.255.255
Default: 0.0.0.0
Start/Stop Activates the route tracing towards the
specified IP address.
To stop the tracing, re-select this option or
exit the Trace Route menu.
Only one route tracing session is allowed at a time.
6.5 Troubleshooting
The following troubleshooting chart is based on LED indications or other inputs.
Use this chart to identify the cause of a problem that may arise during operation.
For detailed description of the LED indicators functions, refer to
Chapter 3
.
To correct the reported problem, perform the suggested remedy actions. If a
problem cannot be resolved by performing the suggested action, please contact
RAD technical support (see
Section 6.8
).
Table 6-67. Troubleshooting Chart
Fault/Problem Probable Cause Remedy Action
The unit is “dead”
(POWER LED is off) No power Check that both ends of the power
cable are properly connected.
The unit is “dead”
(POWER LED is off) Blown fuse Disconnect the power cable from
both ends and replace the fuse with
another fuse of proper rating.
Note