Ace ACE-3205, Инструкция по установке и эксплуатации

Страница: 201 / 418

Installation and Operation Manual Chapter 4 Configuration
ACE-3105, ACE-3205 Ver. 5.2 Configuring for Operation 4-111
Parameter Description Possible Values
TX queue The priority of the PW in the outbound direction
via the Ethernet port. Not relevant when the PW
subtype (see above) is clock recovery.
Note: Clock distribution PWs are automatically
assigned with the priority level of 1 (above 2),
which cannot be changed.
2 (highest priority)
3
4 (lowest priority)
Default:
4 for ATM VP 1 to 1,
ATM VC 1 to 1,
ATM VP N to 1,
ATM VC N to 1 and
AAL5-SDU
2 for SAToP and
Basic CES PSN
OAM mode Determines whether the OAM feature (using
VCCV-BFD messages) is enabled for this PW.
Not relevant if the PW type is SAToP, Basic
CES PSN or AAL5-SDU.
For more information about the VCCV-BFD
functionality, refer to
Appendix F .
Disable
VCCV-BFD
Default: Disabled
Detection
multiplier The negotiated transmit interval, multiplied by
this value, provides the detection time for the
transmitting system. Relevant only if the OAM
mode (see above) is set to VCCV-BFD. 2–60
Default: 5
Min TX interval
(
μ sec)
The minimum time interval in microseconds that
the system uses between transmitted BFD control
packets. Relevant only if the OAM mode
(see above) is set to VCCV-BFD. 1000000–4294967295
Default: 1000000
Max RX interval
(
μ sec)
The minimum time interval in microseconds that
the system uses between received BFD control
packets. Relevant only if the OAM mode
(see above) is set to VCCV-BFD. 1000000–4294967295
Default: 1000000
• The general PW parameters cannot be changed dynamically (on-the-fly),
except the OAM mode.
•
Pseudowires of (Type = ‘Basic CES PSN’) & (Sub type = ‘Clock recovery’) & Peer
are routed via the router interface over DSL VCL and will be rejected if
Ethernet port 2 is not disabled.
•
Pseudowires of (Type = ‘Basic CES PSN’) & (Sub type = ‘Clock distribution’) &
Peer cannot be routed over DSL VCL.
Note