Ace ACE-3205, Инструкция по установке и эксплуатации

Страница: 188 / 418

Chapter 4 Configuration Installation and Operation Manual
4-98 Configuring for Operation ACE-3105, ACE-3205 Ver. 5.2
Configuring the LDP Interface Parameters
The LDP interface can be referenced to one of the existing router interfaces.
³
To access the LDP interface parameters:
•
From the LDP menu, select Interface.
The Interface menu is displayed.
ACE-3205 – RAD Data Communications
Configuration> Applications> MPLS> Signaling protocol> LDP > Interface
1. Router interface ... (1)
IP address ... (192.168.238.10)
2. LDP mode ... (Enable)
3. Basic Hello mode ... (Disable)
>
Please select item <1 to 3>
ESC-previous menu; !-main menu; &-exit
Figure 4-69. LDP Interface Menu
Table 4-62. LDP Interface Parameters
Parameter Description Possible Values
Router interface ID number of a previously defined router interface
on which the LDP basic Hello should be activated.
You can enter a different number to display another
interface's details. 1–32
IP address Displays (read-only) the IP address of the router
interface selected above. 0.0.0.0 –
255.255.255.255
(must match the IP of
the router interface)
LDP mode When enabled, LDP is activated on the
selected router interface. Can be enabled only for
Ethernet interfaces.
Cannot be changed when the general LDP mode (see
Table 4-61 ) is enabled.
Enable
Disable
Default: Disable
Basic Hello mode Select whether Basic Hello should be activated on
the router interface. Visible only when the LDP mode
is enabled (see above).
Note:
• Should be enabled for every router interface on
which LDP basic discovery is enabled.
•
There can be only one router interface
supporting basic Hello over a single physical port.
• Cannot be changed when the general LDP mode
(see
Table 4-61 ) is enabled.
Enable
Disable
Default: Disable