Ace ACE-3205, Инструкция по установке и эксплуатации

Страница: 128 / 418

Chapter 4 Configuration Installation and Operation Manual
4-38 Configuring for Operation ACE-3105, ACE-3205 Ver. 5.2
4.3 Configuring for Operation
This section describes in detail how to configure the parameters needed for
normal operation of the unit:
• Configuring the Physical Layer Parameters
• Setting the Clock Source
• Configuring the Logical Layer Parameters
• Configuring the Application Parameters .
Configuring the Physical Layer Parameters
This stage consists of configuring the physical layer parameters of the Ethernet,
E1/T1 and SDH/SONET ports.
•
Depending on the hardware configuration you purchased, not all
functionalities listed and explained in this manual are actually available.
• In some menus you are required to select the port number. In general, for
E1/T1/J1 ports the number can be 1 to 4/8/16 (1–4, 1–8 or 1–16, depending
on the number of ports in your unit).
³
To access the physical layer port options:
1. From the Configuration menu (see
Figure 4-2
), select Physical Layer.
The Physical Layer menu is displayed.
ACE-3205 – RAD Data Communications
Configuration> Physical layer
1. Port >
>
Please select item <1 to 1>
ESC-previous menu; !-main menu; &-exit
Figure 4-32. Physical Layer Menu
2. From the Physical Layer menu, select Port.
The Port menu is displayed.
Note