Ace ACE-3205, Инструкция по установке и эксплуатации

Страница: 145 / 418

Installation and Operation Manual Chapter 4 Configuration
ACE-3105, ACE-3205 Ver. 5.2 Configuring for Operation 4-55
Parameter Description Possible Values
Port number Number of the port that is used as the
master clock.
Note:
• It is not permitted to assign the same
port number to both the master and the
fallback clocks.
• IMA group can be chosen only if it has a
TRL (timing reference link).
•
1–4/8/16 for one of the
E1/T1 ports
• 1–4/8/16 for one of the
IMA groups
• Pseudowire channel
number for PSN clock
• 1–4 for SHDSL
Default: 1
Station clock
type The type of the Station clock in case the
fallback clock is the Station clock 1
E1/T1
Default: 1
Configuring the Logical Layer Parameters
At the logical layer you can configure PPPoE protocol and Abis optimization
parameters, if such features are used and required in your application.
•
PPPoE parameters – ACE-3105, ACE-3205 allows initiation of PPPoE sessions
for retrieving IP addresses of all data, voice and management sources, to
allow HSPDA connectivity in a variety of DSL-based cellular backhaul
applications.
•
Abis parameters – E1 traffic can be set to work in Abis optimization mode.
Setting Logical PPPoE Entities
³
To access PPPoE protocol options:
1. From the Configuration menu (see
Figure 4-2
), select Logical Layer.
The Logical Layer menu is displayed.
ACE-3205 – RAD Data Communications
Configuration> Logical layer
1. PPPoE >
2. Abis >
>
Please select item <1 to 1>
ESC-previous menu; !-main menu; &-exit
Figure 4-43. Logical Layer Menu
2. From the Logical Layer menu, select PPPoE.
The PPPoE menu is displayed.
3. Configure the PPPoE parameters as illustrated in Figure 4-44 and Table 4-37 .