ZES ZIMMER LMG450, User Manual

Page: 51 / 306

Z E S ZIMMER Electronic Systems GmbH Chapter 4
51
Li for line synchronisation
Ex for external synchronisation
As (inverse) for asynchronous (no synchronisation)
The lower information can be:
‘LF’ (inverse displayed ) indicating that the signal of the channel is low pass filtered.
The implemented ‘A’ and ‘B’ indicator show you, to which group the channels belong to.
•
The time base indicator shows the actual chosen cycle time. The bar below this number
shows how much of the cycle time is over.
•
The mode indicator. In this line you see the chosen measuring mode. Possible values are
‘Normal’, ‘prCE’, ‘CE-Flk’, ‘HRM100’ and ‘Trans’.
In the line below ‘Active’ indicates, that the display is updated with measuring values.
‘Freeze’ indicated a frozen display. The current displayed values don’t change until ‘Active’
is chosen again (key Freeze).
•
The remote indicator. ‘Rem’ indicates that the instrument is remote controlled by a PC.
Some setting can now only be done by the PC but not at the front panel. ‘Loc’ indicates,
that the instrument works as a stand alone instrument.
•
In the last line you see the current chosen wiring.
4.4 General menues
If you are in a sub menu of a menu, you can reach the main menu by pressing the correct
softkey, until you are in the main menu or you can press the menu button (e.g. IF/IO) again.
Here you find the description of menues which are equal for all measuring modes.
4.4.1 Misc.
Globals tab
Here you can do 4 settings:
Date Here you can enter the actual date. This date is used inside the instrument.
Time Here you can enter the actual time. This time is used inside the instrument. Instead
of the ‘:’ you have to enter a ‘.’.
Contr Here you can setup the contrast of the display.
Color Here you can set-up the colours of the display.