ZES ZIMMER LMG450, User Manual

Page: 166 / 306

Interfaces (IEEE option L45-O1) LMG450
166
Bit 1: Set if any of the harmonics was > 100% of the allowed limit, cleared otherwise.
Bit 2: Set if the voltage amplitude was not within the limit, cleared otherwise.
Bit 3: Set if the frequency was not within the limit, cleared otherwise.
Bit 4: Set if the crest factor was not within the limit, cleared otherwise.
Bit 5: Set, if the peak value is not within 90°
±
3°
10.2.4.1.7.9.3 :HWCFactor? FLCF?
SCPI: :FETCh[:SCALar]:HARMonics[:VOLTage]: HWCFactor? /qonly/ <list>|
:READ[:SCALar]:HARMonics[:VOLTage]: HWCFactor? /qonly/ <list>
SHORT: FLCF? /qonly/ <list>
ID: n/a Mode: prCE
Type: float Suffix: 1...4
Value: n/a List: 0...31 for half wave number
Unit: n/a Group: n/a
Reads the voltage crest factor of the half waves. After each measuring cycle over 16 periods
you can get 32 values.
10.2.4.1.7.9.4 :IAMPlitude? HUZA?
SCPI: :FETCh[:SCALar]:HARMonics:VOLTage:IAMPlitude? /qonly/ |
:READ[:SCALar]:HARMonics:VOLTage:IAMPlitude? /qonly/
SHORT: HUZA? /qonly/
ID: n/a Mode: prCE
Type: float Suffix: 0...4
Value: n/a List: 0...5 for interharmonics number relative
to start position
Unit: V Group: n/a
Reads the interharmonics of the voltage. To define the analysis area see command 10.2.10.8.2,
‘:ISTart HNRZ’
10.2.4.1.7.9.5 :LIMit? HULM? UL
SCPI: :FETCh[:SCALar]:HARMonics[:VOLTage]:LIMit? /qonly/ <list> |
:READ[:SCALar]:HARMonics[:VOLTage]:LIMit? /qonly/ <list>
SHORT: HULM? /qonly/ <list>
ID: UL Mode: prCE
Type: float Suffix: 1...4
Value: n/a List: 0...40 for order
Unit: V Group: n/a
Reads the limits of the harmonics of the voltage.